The HUNI BADGER’s portable design makes it easy for you to vaporize your favorite herbal extracts anytime, anywhere. It is powered by a single rechargeable 18650 Lithium-Ion battery paired with a one-button control: Press 5 times to turn on and the square LED indicator glows white. Once the device is turned on, the ceramic tube heating element warms up to operating temperature in merely ten seconds. After it's heated up, you’re ready to make contact with your favorite extracts to produce dense and flavorful vapor clouds. As a safety feature, the device will automatically shut off after 60 seconds of use. Also included within the magnetic cover is a removable glass container we call the HuniPot. You can used it to conveniently store and use your extracts. The included 14mm and EGO adapters works directly as mouthpieces, or can be attached to optional bubblers for water filtration if desired.
Waterproof Hard Case
Huni Badger Unit
High Temp HuniTip (installed)
Low Temp HuniTip
510 eGo Adapter
3 x HuniPot Extract Containers (One stored in magnetic cap)
3 x Pipe Cleaners
2 x Replacement O-rings
(Adapters double as a mouthpiece or can be used for water filtration attachments)
*Requires an 18650 battery, 20A or above recommended for best performance (NOT included with kit)
Pull off magnetic battery cover on the side of the Huni Badger to install an 18650 battery with the positive (+) and negative (-) connections matching the markings on the inside.
Pull open the magnetic cap on the bottom of the device to reveal the mouthpiece stored within the same compartment as the HuniTip heating element.
Slide open the dust cover on top of the device to expose the threaded airway.
Thread in the mouthpiece clockwise until snug.
Prepare your extracts for use.
Press the power button 5 times to turn on the Huni Badger. The logo on the button will glow, the LED light turns on, and the HuniTip begins to heat up immediately.
The Huni Badger reaches operating temperature in roughly 10 seconds. CAUTION: HOT! NEVER TOUCH THE HUNITIP BEFORE IT HAS COOLED DOWN.
Inhale gently through the mouthpiece while dabbing the HuniTip directly onto your extracts.
Note: The device will automatically turn off after 60 seconds as a safety feature. To continue use, press the power button 5 times and the device will be ready to go again.
Make sure device is turned off. (LED and power button light should both be off)
Unscrew the mouthpiece and shut the dust cover.
Replace mouthpiece and HuniPot back within their compartments in the magnetic cap.
Insert HuniTip into the mouthpiece compartment and secure magnetic cap.
BMAX 3 slot battery charger
compatible with 10440 14500 16340 16650 14650 18500 18650 and 26650 model batteries
doubles as battery pack
input voltage DC 5V 1-2A
output voltage DC 4.2V 1000mA
Imren 18650 3.7 V battery (can use with Huni Badger)